Chosen Solution
Hi all, So I have this 11PM that has a dead battery (Which is Apple original), no problem I’ll replace the battery. After replacing the battery I found that the device turned on but was stuck at 0% and not charging, it would also not show any battery information on 3uTools with the battery value and the ex-factory value both being at N/A, an indication that it is not reading information from the bottom connector. After checking all the connections I tried a different battery from a different reputable supplier but have exactly the same issue. Both of these batteries give me all of their information on my jc v1s just not in the iPhone and thus although it does turn on it will not charge but it does still detect USB. I should also note that the iPhone does not draw any current from a wall socket. Any advice on next steps? Thank you, Tom
Sounds like a problem with the charge port (the original battery may not even need replacing) The phone only turns on because replacement batteries are usually (should be) shipped with some charge. I can’t explain the zero percent indication though, other than that there maybe issues with your replacement batteries. Do you get the same result charging it via a wireless charger?
