Chosen Solution Hello. I have a P145 Keurig Office Pro Coffee Maker. The part with a spring on it down in the bottom of the reservoir has come out. It comes out from the outside of the tank. Now it won’t stay in the hole at the bottom of the reservoir. Is there something I’m missing? Update (11/02/2022) I’m made a mistake on the model number. It’s a B145. I believe the part is called a spring loaded valve....
Chosen Solution I locked my self outta my device RCA Viking Pro 2in 1.i need to factory reset ,how do I do that? There’s an old thred on resetting the device here: How to reset the password
Chosen Solution The display does not work when I plug both the power cable and Thunderbolt cable into my Macbook Pro. However, if I plug a Tbolt cable from the Tbolt display to the MBPro, the display works as expected. I have also: Updated the firmware, did an NVRAM reset, did a SMC reset, checked all board connections multiple times, and the magsafe power plug works as expected. Any Ideas, folks?...
Chosen Solution I recently upgraded my iMac’s storage from original 1 Tb HDD to Intel PCIe SSD using an adapter. Meanwhile, I totally removed the original HDD (and SATA cables) and only keep the intel PCIe SSD as the sole hard drive. New OS Catalina installed on this ssd as well. It works so far so good. I did not notice any unusual fan spinning either. I am wondering if this is safe to keep only one PCIe SSD and remove the original HDD completely?...
Chosen Solution I have a 27” iMac mid 2011 and suddenly the display went blank. I checked the onboard diagnostics and LED 3 and 4 are off. I purchased a new graphics card and logic board but now the same problem. LED 1 and 2 turn are on and LED 3 and 4 are off. What is the solution ? Information directly from the source: LED 3 Indicates that computer and video card are communicating....
Chosen Solution Hello there!People I need your help, Few months ago, my macbook pro suddenly blacked screen while I was working. After plugging in the charger, I couldn’t boot it up again… I contacted the apple support which tried to make me perform a bunch of actions like reset SMC and blablabla. Nothing could work. Then, I brought it to an apple reseller for a diagnostic and they told that the motherboard must be dead....
Chosen Solution My charger will not charge and flashes with an error 188 code. Any ideas how to repair ? Hi @monty_a2 , I don’t know but maybe contact imuto (support@imuto.net) and ask them. Also have seen online that some of their products carry an 18 month warranty which may also apply to yours. If it is not that old yet try a warranty repair or replacement. You may need the receipt or the order number though to qualify....
Chosen Solution Hello, I bought used iPhone 6s in perfect condition, but I’ve got problem with it. I’m a runner and I use GPS trackers a lot. I tried to change the app from Endomondo to Runtastic but there was no effect. My tracking is full of waves and it is “rounded”. I installed app called GPS Status. It shows sometimes my position with 10m accuarcy but the most of the time there is +-65m and even if the phone is not moving it shows speed occasionally....
Chosen Solution My iPad Pro 10.5 inch 2017 screen is turned black completely. I connected it to iTunes and did full hard reset — updated the software to ios13 as well. I can see the iPad details in iTunes but the screen is still black. I turned on the voice over with triple click on the home button and I can hear the voice when I click on the screen anywhere but no luck with the screen....
Chosen Solution Hey guys so I’ve read a fair bit about this issue but mine seems to be something other than what I’ve read. so long story short. I was using the phone, all was well until it suddenly died.. at 63% battery! So I did what most would do and plugged it in to the genuine apple charger with its genuine apple lead. Phone came on.. no charging icon just straight to the apple logo, but not any further sort of in a boot loop....
Chosen Solution I keep Getting the message The iPhone “iPhone’“ could not be activated because the activation information could not be obtain from the device. Disconnect your iPhone, make sure the sim card is inserted correctly and, if you use a sim pin , tap unlock to enter it and the reconnect iPhone. Which I have replaced my sim card with a brand new one after trying to restore and update many of times....
Chosen Solution Hi everyone, My mother has an iPhone 5 and started complaining about the battery for a while then the iPhone died. It now shows the low battery symbol with the cable at the bottom, what is shown usually when the battery is dead. When it is connected to power the cable disappears but the low battery symbol stays forever and it never turns on. It is not recognized by iTunes or even the laptop....
Chosen Solution Hello! I am working on an iPhone SE which has a randomly unresponsive screen. The display had a small crack from the upper edge to the earpiece, so I assumed the display unit would be damaged. However, after I replaced the display unit with digitizer (not the camera + sensor module and the metal shield), the display still behaves the same way. Any ideas what the issue is? It behaves almost like a loose contact....
Chosen Solution I charged my iPhone X with my smart battery case last night, and this morning my phone was at 91% and it said the accessory might not supported, then I found out the charging case works with my friend’s phone, and I can’t charge my phone with both case and charger. I have a micro USB with an apple official micro to lightning adapter, and it works, but when i flip the charger to the other side it won’t work, how I can fix it by myself, if it is not possible, how much will it cost to fix it?...
Chosen Solution Just wondering if still any possibility to recover the data from this HD, regardless of cost. Added photos for Motherboard states: The NAND is tied to the CPU, Baseband and some other IC’s. You would need to put the NAND back in the same board and get it to boot to retrieve data. You cannot retrieve data by extracting it from the NAND. The state the NANDS in it would be extremely difficult and time consuming but I wouldn’t say it is impossible....
Chosen Solution i have been having trouble with my iPod classic since i took it to Mexico and connected it to a laptop over there. before i connected to the laptop, everything was working well with it, songs didn’t pause randomly, etc. but now it doesn’t want to sync all the songs i have in my library it mostly syncs up to 1gb of “selected” songs. i cant even put videos in it....
Chosen Solution Whenever i drop my ipod from any distance it will fade into a grey or lined screen and will not respond to any type of reset until i let it die and plug it back in. any way to fix this without letting it die? i am guessing it is either the screen; motherboard or something popped out of the holding in the iPod. I can not say that this might be for sure though… i had never owned this device....
Chosen Solution For the ipod touch 5th gen can i just use my double sided red tape then cut thin strips to attach the frame bezel to the screen or do i need a stronger tape/adhesive? l already removed the bezel from the screen and tried to clean up the old adhesive as best as i can. Sure that should be fine iPod Touch 5th Generation Display Assembly Replacement
Chosen Solution Hello, I bought a new battery for my iPod 5G and replaced it by myself. After all was done, the device powered up and worked normally but doesn’t charge. The middle pin of the connector got a little bit damaged as I soldered it, but not the cable. So you should replace the connector.
Chosen Solution It seems to me that my Asus Transformer Infinity TF700T is lagging to much because it has only 1GB ram.. I have Samsung note2 with 2GB ram, and this phone works much much smoother and faster than Asus tablet.. So my question is can I upgrade somehow Asus from 1GB to 2GB RAM? Thx I am really sorry to inform you that its not possible on any Tablet. You can store data though on the SD card!...
